Camshaft Position Sensor Jeep
Camshaft Position Sensor Jeep. Carefully attach electrical connector to camshaft position sensor. 2 camshaft position sensor problem of the 2000 jeep grand cherokee.
It's tight but you can get to it and the harness. The sensor and drive shaft assembly is located on the right side of the engine near the oil filter. I've been having the same issue intermittently for the past 3 years.
I Have A 1992 Yj 4.0 Straight 6 Cyclinder Automatic Transmission.
These 8 volts or 5 volts are provided by your 5.2l jeep grand cherokee's fuel injection computer. Where is the camshaft position sensor on a jeep liberty 2.5 crd. I had my check engine light code read at a local shop.
Connect The Electrical Connector (1) To The Sensor.
Camshaft position sensor, camshaft sensor replaces: We offer a full selection of genuine jeep camshaft position sensors, engineered specifically to restore factory performance. Tighten the mounting bolt (2) to 9 nm (80 in.
Free Same Day Store Pickup.
The camshaft position sensor monitors the position of the camshaft and reports that data to the car’s onboard computer system. Please narrow the cam position sensor results by selecting the vehicle. That particular cps is located right at the firewall on the passenger side.
Install The Negative Battery Cable.
Making sure the cmp sensor has power. It does not determine ignition timing. Install the air cleaner to throttle body hose, connect the inlet air temperature sensor electrical connector.
Installation At An Angle May Damage The Sensor Pins.
The camshaft position sensor (cmp) on this engine is bolted to the top of the oil pump drive shaft assembly. What code are you getting? If your wrangler has this code, it means that the pcm (powertrain control module) has detected that the camshaft position.
Post a Comment for "Camshaft Position Sensor Jeep"