How To Change Throttle Position Sensor Dodge Ram 1500

How To Change Throttle Position Sensor Dodge Ram 1500. In this video, i demonstrate the steps required to replace the throttle position sensor in my 2001 dodge ram 1500 with the 5.9l magnum engine.i am not a prof. First, disconnect the electric connector from the sensor.

Dodge RAM 1500 Questions throttle position sensor from www.cargurus.com

The best part is, our dodge ram 1500 throttle position sensor products start from as little as $28.49. Insert ignition key and turn the key to “on” not start. You should see a mark like “on” on the side of the ignition.

Source: www.ebay.com

In this video, i demonstrate the steps required to replace the throttle position sensor in my 2001 dodge ram 1500 with the 5.9l magnum engine.i am not a prof. (c) leave ignition switch on for a minimum of 10 seconds.

Source: www.youtube.com

Although the engine kept running, i restarted cruise again, and it worked. Under hood, center, upper engine area, rear of intake manifold, mounted in distributor if this is helpful.please leave.

Source: dodgeforum.com

You should see a mark like “on” on the side of the ignition. You need wait for all dashboard light to go off.

Source: www.youtube.com

Insert ignition key and turn the key to “on” not start. (c) leave ignition switch on for a minimum of 10 seconds.

Source: www.cargurus.com

Service and repair removal the tps is located on the side of the throttle body. (c) leave ignition switch on for a minimum of 10 seconds.

Source: dodgeforum.com

Although the engine kept running, i restarted cruise again, and it worked. Don’t attempt this if you’re uncomfortable working with electricity, as removing the wrong fuse or cable from your battery could be dangerous.

Buy Dodge Ram 1500 Throttle Position Sensor (Tps) Online And Get Free Next Day Delivery On Qualified Purchases, Or Pick Up Your Parts At A Nearby Autozone Today.

You can do this by following the steps below; Depending on what type of vehicle you have this job could get expensive. This article covers troubleshooting diagnostic trouble codes (dtcs) p0121, p0122, p0123 on the 5.2l and 5.9l dodge ram pick up (or van).

Unplug The Throttle Position Sensor Connector.

Press the accelerator on the floor for 15 seconds. Loosen and remove the two retaining bolts. In this video, i demonstrate the steps required to replace the throttle position sensor in my 2001 dodge ram 1500 with the 5.9l magnum engine.i am not a prof.

There Are Two Torx Head Screws Holding The Sensor To The Throttle Body.

Disconnect the negative battery cable. You should see a mark like “on” on the side of the ignition. You need wait for all dashboard light to go off.

Year Range For Dodge Ram 1500 By Model

Service type throttle position sensor (tps) replacement: Don’t attempt this if you’re uncomfortable working with electricity, as removing the wrong fuse or cable from your battery could be dangerous. I ran through the codes by turning the ignition on/off 3 times, and got p0121 throttle position sensor circuit insufficient activity.

Service Type Throttle Position Sensor (Tps) Replacement:

If equipped with a 5.7l, also perform the following 3 steps: Remove tps from throttle body. (b) turn ignition switch on, but do not crank engine.