Skip to content Skip to sidebar Skip to footer

2010 Chevy Impala Camshaft Position Sensor Location

2010 Chevy Impala Camshaft Position Sensor Location. The camshaft position sensor is located on the right side of the engine, below the intake plenum. By continuing to use this site you consent to the use of cookies on your device as described in our cookie policy unless you have disabled them.

For 20092011 Chevrolet Impala Camshaft Position Sensor
For 20092011 Chevrolet Impala Camshaft Position Sensor from www.ebay.com

The crankshaft position (ckp) sensor is located on the right side of the engine, above the transaxle and just below the exhaust manifold. By continuing to use this site you consent to the use of cookies on your device as described in our cookie policy unless you have disabled them. This vehicle may be subject to voluntary recall, campaign i.d.

Malibu Chevy 2008 3.6 Engine Where Is The Location.


You can see it from underneath the car if you look straight up in between the oil and transmission pan. If you are having the job done at a repair shop or at the dealer it will cost between $180.00 and $250.00 (us). To get to it you go under the car, then unplug the sensor, remove it and reverse the process to install the new one.

By Continuing To Use This Site You Consent To The Use Of Cookies On Your Device As Described In Our Cookie Policy Unless You Have Disabled Them.


After replacement, ecm reprogramming is required. Posted on may 18, 2018. Service type camshaft position sensor replacement:

Whereas If You Where Doing The Job Yourself The Sensor Alone Will Cost Between $25.00 And $65.00 (Us).


This vehicle may be subject to voluntary recall, campaign i.d. 2010 chevy traverse 3.6 p0008 p0017 p0221 previously i have codes for bank 2 cam sensor and few misfires on bank 2 due to a 02 sensor. Duralast camshaft position sensor su13346.

Camshaft Sensor Service Costs Will Vary Per Manufacturer And Depend On The Location Of The Sensor.


The chevy impala utilizes a crankshaft position sensor in order to regulate the engine timing. The crank position sensor is on the firewall side of the engine, just above the oil pan lip and in line with the exhaust outlet on the manifold. But you can take it out from above.

If You Are Accessing Your Vehicle From Underneath You Can See It Between The Oil And Transmission Fluid Pans.


Service type camshaft position sensor replacement: The sensor is located on the firewall side of the engine. Service type camshaft position sensor replacement:.

Post a Comment for "2010 Chevy Impala Camshaft Position Sensor Location"