How To Install Engine Coolant Temperature Sensor
How To Install Engine Coolant Temperature Sensor. Remove the battery and battery tray. The old part twisted and pulled out, and sat with the electrical connector straight up.
Replace the coolant you previously drained, or refill the radiator with fresh coolant. I'm assuming no tools are needed, as none were needed to remove it. Make sure the end of the wire is clean and plug it back into the terminal end of the sensor.
A New Sensor Was A Little Bit Different.
Do not over tighten the sensor or you will crack the porcelain which will cause the sensor to send false information to the computer. The area is small, so it's either your hand or your vision. Plug the wiring harness back into the rear of.
Check For Coolant Leaks Around The Sensor Threads.
Turn the engine on and let it get up to operating temperature. Opening time as the engine reaches normal operating. Replace any other parts you had to disassemble.
The Tip Of The Ect Sensor Protrudes Into One Of The Cooling System.
Disconnect the negative battery cable. Im trying to replace the engine coolant temp sensor on my 2007 ford fusion sel 3.0l v6. Install the electrical connector by pushing it into the sensor.
Start The Engine And Let It Idle.
A coolant temperature sensor (cts) (also known as an ect sensor or ects (engine coolant temperature sensor) is used to measure the temperature of the coolant/antifreeze mix in the cooling system, giving an indication of how much heat the engine is giving off. I'm assuming no tools are needed, as none were needed to remove it. You will have to get a visual before putting your hand through;
A Code Of The Water Temp Sensor Was 076919501C.
The new one isn't clicking into place and is sitting at an angle. Take a look at the image below. Go easy on the torque and use a new sealing washer.
Post a Comment for "How To Install Engine Coolant Temperature Sensor"