How To Adjust Tps Sensor
How To Adjust Tps Sensor. The manual has you place a 0.0177 (0.45mm) feeler guage between the stop screw and the throttle pulley to open the butterfly and then adjust the tps right to where the ips (pins 3 and 4) switches from closed to open. This is a difficult step because the sensor wants to move as you tighten down the set screw.
The tps can be seen in the picture. To get the minimum reading just click on read and it will automatically set it for you and as for the maximum you have to floor the gas pedal(wot) and then click on read then save the changes and re upload the map. So the throttle would have to be a little more closed for the same tps response).
To Start, I Threw A Code (Forget The Code Number, But It Was For The Tps Sensor) And The Car Was Ideling Really High When Cold, Then Dropped To About 1000 When Warm.
If so, fully tighten the tps screws. So the throttle would have to be a little more closed for the same tps response). (4) remove the hose from the pressure sensor on the firewall and tuck it down out of the way.
Just Use Your Meter To Find What Is What.
If it does jump around or is not a smooth definite increase in voltage, you may have a faulty tps. Leave the screws loose so you can still rotate the sensor during the adjustment. Double check that it still reads 0.9k ohms when closed.
How To Replace / Calibrate Your Throttle Position Sensor Tps (Honda) Watch Later.
Today we're replacing, and adjusting, a throttle position sensor. Check for voltage at the harness nearest to the tps bolted to the intake manifold. Now, while you have your voltmeter connected and reading.
Tighten The Screw Down And Verify The Voltage Again, Making Sure That The Butterfly Is Completely Closed For That Reading.
The manual has you place a 0.0177 (0.45mm) feeler guage between the stop screw and the throttle pulley to open the butterfly and then adjust the tps right to where the ips (pins 3 and 4) switches from closed to open. Loosen the jam nut and unscrew the throttle stop screw all the way so that the throttle blade closes fully against the throttle body itself. Slowly move the throttle to wot (wide open throttle) and carefully monitor the voltage.
The Tps Can Be Seen In The Picture.
To make adjustments to your tps you will need the following tools: Make adjustments the way i mentioned before on the tps to achieve the correct resistance readings. It should go steadily up and not “jump” around.
Post a Comment for "How To Adjust Tps Sensor"