Testing A Coolant Temp Sensor
Testing A Coolant Temp Sensor. Then check the sensor in the warm sensor (after the engine is run). I boiled a pot of water, put in a thermometer and the sensor and took resistance readings as the temp dropped.
Like noah said, you have to heat up the coolant temperature sensor while measuring the resistance across its terminals with a multimeter. Next, remove the wire from sensor terminal and connect the red lead to the terminal end of the coolant. Unplug the electrical connection to the switch with your hands, revealing two posts on the sensor.
It’s One Of The Few Parts In Your Car That’s Cheap Enough That It’s Often Easier To Just Replace It Rather Than Spend Time Testing It.
Let it sit for a bit, fired it back up, went half a mile, and it came back on. Discussion starter · #3 · jan 26, 2005. If it doesn't change in that approximate way, then change it!
Coolant Temperature Sensors Are Used By The Fuel Management System To Detect The Engine's Operating Temperature.
You can start by connecting volt ohm meter’s black lead to a solid grounding like the metal part of your hood. Your vehicle’s temperature sensor is an important component of your engine’s cooling system, so if you’re having problems with your car or truck overheating, you may have a faulty sensor. Depending on the sensor information, the control unit adapts the injection time and firing angle to the operating conditions.
If The Coolant Temperature Sensor Is Off By A Lot, It Can Prevent The Engine From Starting, Make It Run Poorly And Guzzle Gas.
Unplug the electrical connection to the switch with your hands, revealing two posts on the sensor. The engine coolant temperature sensor is located on the back of the right cylinder head and is integral with the ect sensor. Shut it off, had coolant in the bottle, tunnel coolers didnt feel that warm.
I Then Put It To A Graph And Looked At It.
To test it, you unplug the connector and measure the resistance across its teminals with an ohmmeter. If you suspect the sensor isn’t working properly, you can test a coolant temperature sensor or simply replace it. Testing the coolant temperature sensor is a very quick process.
The Image Below Shows The Results.
The engine coolant temperature sensor is a negative coefficient thermistor. You can then proceed to remove the wire from the sensor terminal and connect the red lead to the coolant temperature sensor’s terminal end. How do you test a coolant sensor?
Post a Comment for "Testing A Coolant Temp Sensor"