Skip to content Skip to sidebar Skip to footer

Carrier Infinity Sensor Error

Carrier Infinity Sensor Error. The short flash is 0.25 seconds on and the long flash is 1.0 second on. Ask them how much refrigerant they added.

Carrier Infinity Series thermostat problem YouTube
Carrier Infinity Series thermostat problem YouTube from www.youtube.com

The short flash is 0.25 seconds on and the long flash is 1.0 second on. Carrier infinity system malfunction sensor error on infinity communicating systems only, low ambient. The motor of the device is unable to sense the problem.

The Infinity Control And Room Sensors Should Not Be Mounted:


If the vfd software is not the most current, then the vfd should be reprogrammed manually using the infinity control or the carrier service tech app. To remove the alert from the lcd screen, you. How do you clear the error code on a carrier infinity thermostat?

On A Section Of Wall Without Pipes Or Ductwork.


No message is displayed on the screen regarding the problem faced by the appliances. The control board monitors the coil temperature sensor for a defrost. The only other possible reason i could think of for this to happen is if humid air was being pulled through the hole in the wall that the thermostat wire comes through behind the thermostat.

Use The Scroll Button To Go Through The Components.


The short flashes indicate the first digit in the status code, followed by long flashes indicating the second digit of the error code. To make the ‘accessory status’ menu appear on the lcd screen, hold the button located next to the right arrow (it might. Carrier infinity series ac error codes the codes are flashed by a series of short and long flashes of the status light.

The Short Flash Is 0.25 Seconds On And The Long Flash Is 1.0 Second On.


Carrier ac error codes and troubleshooting. Ask them how much refrigerant they added. F0 low charge or refrigeration system interruption.

The Error Is Definitely Either A Refrigerant Issue Or An Issue With A Sensor.


Make sure power is applied to the indoor unit, and the amber led is lit on indoor control circuit board. Recheck wiring to abcd on all devices. As the humidity sensor is built into the systxccuid01 you're going to have to have the thermostat replaced to resolve the issue.

Post a Comment for "Carrier Infinity Sensor Error"